Solid state relay controller
With a 5 inch TFT screen and prepared for special features, like app connectivity, GPRS monitoring and remote control operating.
Genmark Technology
All our gensets are Dutch made in our own production facility near the port of Rotterdam. The technology we use has been collected over the years. The result is a perfect combination between a certified Yanmar Stage V engine, a 24 kW RFL alternator and an in-house designed controller. We take quality seriously; with a fully galvanised frame, high quality steel and robust shock mounts, your genset will last for years to come.
Servicing only takes place after 1000 h or once a year. Combined with the lowest fuel consumption in the field this makes Genmark gensets the most cost efficient gensets available. Our gensets don't have to be removed for servicing. This will save you a lot of time and costs.
18,9KW25,7 hp @ 1.500 rpm
1000HOr once a year service
-30°C / +50°CExtended temperature range
NoADBLUENo minimum load needed
Yanmar engine
Genmark gensets are powered by a Yanmar diesel engine. Yanmar was founded in 1912 in Japan and is a leading expert when it comes to diesel engines.
The Yanmar engine we use is an OEM (Original Equipment Manufacturer) 4 cylinder direct injection diesel engine specially designed for Genmark gensets. The oil pan is enlarged to maximize the operating hours and maintaining the engine takes very little effort. This means you'll have more time to focus on your business!
Some of our key features
1000 hr / 1 year service interval- Extended temperature range: -30 °C to +50 °C
- Enlarged oil capacity
- Bigger starter engine
- 18,9 kW / 25,7 hp at 1.500 rpm or 50 Hz
Our custom engine was installed and tested by Yanmar engineers. The result is a custom engine that meets your requirements and is approved by Yanmar.
Swipe the engine
European emission standard
Stage V
Our custom design Yanmar engine, used in all of our models, is certified according to Stage V regulations. This means our engine has lower emissions than non-Stage V engines, which is mandatory as from the year 2021 according to the European emission standard.
We achieved this certification without the usual drawbacks of Stage V engines. With our Yanmar engine:
- NOAdBlue is needed
- NOIncreased fuel consumption
- NOMinimum load needed to operate properly
In-house electronics department
Genmark controller
Our Electronics Department produces the controller of the Genmark gensets based on the philosophy "less is more". This means we avoid complex, expensive and error-prone operating systems.
Pelican case
Our external controller used on the Undermount unit is built within a Pelican case: the most durable materials, up to the highest IP standards. Position it anywhere on the chassis, no need to crawl under it.
Running hours tracked
To relieve you of any extra administration, the Genmark controller keeps track of the number of running hours. When it's time for the annual service, the controller will let you know. Easy as that.
Designed with RFL
Alternator
The high-quality permanent magnet alternator was designed in collaboration with RFL. A permanent magnet alternator specifically designed for the transport industry.
This unique 24 kW permanent magnet alternator is much smaller, lighter and easier to install than any other alternator available. With over 10 years of research and development, Genmark continues to develop new and efficient cutting edge technology to the highest quality standards.
24KWPermanent magnet
95%Efficiency
3×1Phase circuits with varying loads
See it in practice